Larry, drill a hole in the end of a piece of steel scrap, then weld to the
center of
the head of the bolt. Should give you a handle that will let you break the bolt
loose. John
Larry Hoy wrote:
> Any suggestions on how to remove the flywheel bolts on a B engine? The bolts
> are very flat, and whoever removed them in the past must have barely gotten
>them
> out and now they are basically smooth. I could grind the heads off, then
>remove
> them but I'm open to any and all suggestions.
>
> I have managed to get two of the six out.
>
> Larry Hoy, Denver, CO. USA
> 1967 MGB Roadster, Vintage Racer
> 1969 MGB Roadster, Driver
> 1970 MGB Roadster, Fixer upper
> http://home.cwix.com/~larryhoy@cwix.com
|