No complaints after 1500 miles or so on my ANSA exhaust, except it's hangin'
too low, and taking some abuse on the fun roads.
Before I take a jack and try to bend it up towards the floor (with
questionable results), I thought I'd ask if others have encountered this
problem and fixed it.
Warm with a torch first and push up/shape to fit, maybe? All the stock
hangers are being used and holding, other than the middle that required some
spacers to hook up, which is holding well too...
Aftermarket stuff, I know, I know...but the stock Moss downpipe is rusting
like crazy only at the "Y" pipe, too. ( I painted the whole thing prior to
install and that section is apparently made of bad metal)
I'd just like to "square up" that 3 inch space between the floorboard and
the pipe...the clamp and middle muffler are getting scraped something
fierce.
I'd rather not spend another $200 to replace it eventually.
Dan
73 B
|