john peloquin wrote:
> There is supposed to be a grease seal at the part of the hub closest to
> the base of the spindle. It (of course) has two sides- one with the rubber
> flush with the metal and the other with the rubber slightly below (1/2
> mm?) the metal. Which side goes towards the base of the spindle and which
> goes towards the small end of the spindle?
Think of it this way, you are going to tap it into the hub with a hammer. Now
which side would be most appropriate to accept the hammer blows? That'd be the
flat side.
BTW: Professional mechanics never admit to tapping it home with a hammer.
Bob Allen, Kansas City, '69CGT, '75TR6
|