Hi,
It looks like I will have to change the speedometer drive gear. I can
hold still the cable while driving (speedo removed). I found this out by
a heavyly swinging needle.
But here the Q:
To replace the gear inside the OD, can I just loosen the locknut at the
axle side of the OD, and pull the rear flange? Or do I have to remove
the entire OD assy?
Second:
Do I have to drain the oil? And is the room for the oil the same as the
room for the tranny? Can the oil flow over from one to another?
I have a 4 synchro 67-on OD type and gearbox.
Greetings from a sunny Netherlands.
Rene
--
Rene and Marion van Maanen
Netherlands Europe
SOHC #252
http://support.neth.hp.com/~renevm (intranet HP)
Honda CB360T ['76]
Honda CB350F ['74]
Honda CB750K2 ['75]
MGB GT ['68]
|