In a message dated 4/23/98 9:19:12 PM Eastern Daylight Time,
danray@bluegrass.net writes:
> My brake lights were staying on, so I removed the switch from the housing
> and fiddled with it, pulling the little plunger out and pushing it in. At
> first, the lights just stayed on, then they started going off when I
> RELEASED the plunger...
Dan,
I just re-read your post. Instead of being mis-adjusted, it sounds like the
switch either needs a good cleaning, if you can get it apart, or replacement.
Dan Masters,
Alcoa, TN
'71 TR6---------3000mile/year driver, fully restored
'71 TR6---------undergoing full restoration and Ford 5.0 V8 insertion - see:
http://www.sky.net/~boballen/mg/Masters/
'74 MGBGT---3000mile/year driver, original condition - slated for a V8 soon
'68 MGBGT---organ donor for the '74
|