On Thu, 05 Feb 1998 08:04:52 -0600 Robert Allen <boballen@sky.net>
writes:
, I observed that there seemed to be enough tension to hold the cover to
the head.
>It was the rolled lip at the bottom that prevented the
>cork from laying flat. During installation I would invariably cock some
>part and it would slide away leaving a gap. For that, I took 4 of
>the smallest screws I could find, drilled holes and screwed in place.
Again, the sealer was
>applied liberally to the lip of the cover. The screws were only about
>1/8 inch long and did not go through
"They may be ribbed for her but I bought 'em so I turned them inside
out."
Bob - are you sure this isnt an article you wrote about Monica
Lewinsky??????
- all i did was remove a few words, nothing added - honest!!!
mike robson
69 roadster
70 BGT
72 roadster
_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
Or call Juno at (800) 654-JUNO [654-5866]
|