It's on the right, rear perspective, and decal is oriented so that it
is read from right side, again, rear perspective. So, it's directly
above the distributor and heater valve. The raised area on left was
partially covered by heater hose connecting pipe, so I didn't notice it.
Sorry, I'm new at posting on the list :-)
Glenn
Blake Wylie wrote:
>
> Is it on the right or left raised area? Also, is that from the front
> perspective or the rear perspective? :)
>
> heheh...Thanks, :)
>
> Blake
>
> At 08:09 PM 12/22/97 -0500, Glenn Williams wrote:
> >.....Oops! The correct item# in V.B. catalog is 19, not 18. But, it
> >is #18 in the Moss Edition MGB-07 (electonic catalog, from the web)
> >By the way, the decal is on the top of valve cover, not the side.
> >It is on a raised area, slightly larger than the decal.
> >
> >Glenn
> >
> >Glenn Williams wrote:
> >>
> >> Blake,
> >>
> >> My 70 MGB has only one decal on the valve cover and it's on the
> >> right side. My engine number is 18GH-WE-H29758, VIN# is
> >> GHN5UA197861 G. Date stamped on driver door plate is 1/70.
> >> The sticker can be found in the Victoria British Ltd. MG.35
> >> catalog on page 52, item 18. The decal reads:
> >>
> >> "B.M.C. E.P.A.I. ENGINE EXHAUST EMISSION CONTROL
> >> FOR MAX EFFICIENCY THESE SETTINGS MUST BE
> >> MAINTAINED IDLE R.P.M (HOT)-900 R.P.M. IGNITION
> >> TIMING AT 1000 R.P.M. VACUUM REMOVED 20 B.T.D.C.
> >> CARBURETTER MIXTURE TO BE ADJUSTED BY AN
> >> APPROVED SERVICE STATION TO B.M.C. MANUAL"
> >>
> >> Hope this helps,
> >> Glenn Williams
> >> willga@xtn.net
> >> Johnson City, TN
> >>
> >> 1970 MGB (restore in progress after driving for 20 yrs)
> >> 1988 RX7-GTU
> >> 1988 Toyota Camry
> >> 1995 Mazda 626
> >> Blake Wylie wrote:
> >> >
> >> > One more thing...
> >> >
> >> > Could anyone tell me what valve cover stickers were used on 1970 engines?
> >> > And which sides they were on. This may seems trivial, but I was just
> >> > wondering. :)
> >> >
> >> > Thanks again, :)
> >> >
> >> > Blake Wylie
> >> > 1970 MGB
> >
> >
|