To: | "Vince J. Pujalte" <pujalte@stic.net> |
---|---|
Subject: | Re: Engine break in |
From: | "Scott Gardner" <gardner@lwcomm.com> |
Date: | Sat, 18 Oct 1997 07:24:00 +0000 |
> Scott, > Who is building the super-tight tolerance engine that you referred to? > > -Vince > It's the new Chrysler 2.7L aluminum V-6 for their LH cars. I inadvertantly inserted an extra zero. The "cylinder bores are finished to a tolerance of 0.3 microns (.000012 inch)". Scott P.S. I was just quoting fron the article, but isn't .000012 inch TWELVE microns? Scott Gardner gardner@lwcomm.com www.lwcomm.com/~gardner |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [no mg relevance] LAWS was: Re: Felony Misdemeanor? Was:Re:, Benjamin Ruset |
---|---|
Next by Date: | Re: Midget Kit, Barney Gaylord |
Previous by Thread: | Re: Engine break in, Scott Gardner |
Next by Thread: | MGB exhaust manifold identification, KILE, PAUL D |
Indexes: | [Date] [Thread] [Top] [All Lists] |