| To: | mgs@Autox.Team.Net |
|---|---|
| Subject: | Bolt on Crankshaft Pulley |
| From: | "Thomas James Pokrefke, III" <pokrefke@ocean.st.usm.edu> |
| Date: | Thu, 9 Oct 1997 08:27:33 -0500 |
To the lister who was wondering what size bolt holds the pulley to the front of the crankshaft, the size is 1 5/16". This is also the same size of the nut that holds the hub to the rear axle on wire wheel cars. Thomas James Pokrefke, III 1970 MGB pokrefke@ocean.st.usm.edu http://ocean.st.usm.edu/~pokrefke |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: MG or other LBC artwork on net, Ross MacPherson |
|---|---|
| Next by Date: | Re: This list being used for solicitations?, MIKE LAMBDIN, CANS |
| Previous by Thread: | Hershey, PA, Steve Tritle |
| Next by Thread: | Re: Bolt on Crankshaft Pulley, Art Pfenninger |
| Indexes: | [Date] [Thread] [Top] [All Lists] |