Hello??? James
>Aloha Larry!!!!!!
>
>Thanks for the reply on the oil pressure problem.I just wanted to confirm
>my diagnoses of the problem.I have a couple of more questions on the
>subject,Moss sells main bearing kits from std. to .040 over . Which one do
>i use ? And remove oil pan and pull off each main bearing one at a time and
>replace bearing?I have not done any work to the MG from the cylinder head
>down.
>
>Mahalo
>
>
>James
>
>
If you aren't going to do the whole engine use the std bearings. And yes
pull the pan and replace them one at a time. The front maybe
problematical as, in my experience, it is used for shaft positioning and
has a thrust washer included, which can be replaced in the same fashion
as the bearings turn the old out, turn the new in. Lubricate. Long term -
pull the engine.
|