>Bob:
>
> Where did you get them??
>
>Regards,
>
> Ed
>
>
I bought the hinges from Moss. Turns out the right
hand side needed 1/8 inch removed to make the door fit.
I did this with a hand held electric grinder.
The left hand side was just right the way it was. Before
any more grinding, I measured the door opening and discovered
it is exactly 1/8 inch wider than the right.
So I guess each door is somewhat of a custom job. It would
be nice if the replacement hinges were made on the skinny
side and supplied with shims.
Bob Donahue 'Still Stuck in the '50s'
rdonahue@holli.com
52 MG-TD #17639 under DIY restoration, NEMGTR #11470
71 MGB still in shop, 20 months and counting
|