Hi Dan Masters!!
On Wed, 25 Jun 1997 DANMAS@aol.com wrote:
> Rule # 1 Never allow the connector to be the support for any appreciable
> length of wire.
> Rule # 2 A GOOD X type connection is better than a POOR Y type connection.
> Insert your choice for X and Y.
> Rule # 3 The material you are soldering must be hot enough to melt the
> solder. It isn't good enough that the soldering iron melts the solder.
> Rule # 4 Use the right heat range soldering iron/gun.
> Of course, you already know all this, but it might be helpful for others on
> the list. Anything you would like to add? Did I get it right?
You hit all the important points, and did a lot better job of it than I
could.
TTUL8r, Kirk Cowen (who hasn't tried the lead-less solder yet)
|