In <v02140b00afaaa0742100@[205.160.242.81]>, Paul Gallian wrote:
>I can name that MG TD part in one guess!
>
>Help.
>
> I have a left-over part.
>
>A rounded corner trapezoid with two bolt holes at the base and two at the
>top.
>
>The base is 9 cm, the more or less 90 degree left side is 10.6 cm, right
>side is 11.2 cm and the top 3.9 cm. As you can see (read) this is almost
>a right triangle with the top cut off. It is about 2-3 mm thick and FLAT.
>
>It is similar to but not the same as the tail pipe bracket that attaches to
>the transmission.
>
>Any suggestion? I have looked, looked, and looked in Moss and Abingdon
>catalogs with out success.
>
My bid is that it is one of the two reinforcing plates that sits on
the underside of the sloping part of the firewall. The horn brackets
bolt onto them (I think) and on the right side the starter switch
bracket bolts on the small end. There is nothing but two 1/4 BSF
bolts on the left side, small end.
Do I get a nookie broon for that?
A. B. Bonds
|