mgs
[Top] [All Lists]

Re: TC rear hub oil leak

To: dmeadow@juno.com
Subject: Re: TC rear hub oil leak
From: damitdick@juno.com (W. J. Richard Criswell)
Date: Thu, 30 Jan 1997 15:30:32 EST
David...

Not moody...just messy.

Dick 8>)
Vintage Parts & Products
Camarillo, CA
Have MG will travel


On Wed, 29 Jan 1997 23:55:23 EST dmeadow@juno.com (David C Littlefield)
writes:
>Was the TC moody and irritable for a few days before the procedure?
>Your post was the funniest thing I have ever read on this list.
>
>David Littlefield
>Houston, TX
>
>
>On Wed, 29 Jan 1997 13:16:14 EST damitdick@juno.com (W. J. Richard 
>Criswell) writes:
>>Paul...
>>
>>As an old TC driver I solved the problem this way.  I degreased and 
>>cleaned the axle and hub assembly. Then I worked silicone sealant 
>into 
>>the axle splines from the outside of the hub and left plenty of 
>>sealant all around the axle and a joining hub surface.
>>
>>Then, since we all know the TC is a lady, I stuffed sanitary napkins 
>>inside the hub to absorb any fluid that escaped into the hub.
>>
>>Dick 8>)
>>Vintage Parts & Products
>>Camarillo, CA
>>Have MG will travel
>>
>>
>>On Wed, 29 Jan 1997 21:36:50 +1100 (EST) homestay@infolearn.com.au 
>>(Syl's Sydney Homestay) writes:
>>>I have a persistent rear hub oil leak which I tackled again tonight.
>>>
>>>I reckon diff oil is leaking past the oil seal, working its way 
>>>through the
>>>axle splines where it force fits into the rear hub. Tell tale signs 
>>>being
>>>oil slung to the outer wheel rim after running down the wheel 
>spokes. 
>>
>>>Not a
>>>lot but persistent despite replacing the rear oil seal and rear hub 
>>>gasket
>>>more than once in an attempt to fix it.
>>>
>>>I've seen some axles brazed to the hub - maybe to take up slack and 
>>>maybe
>>>to help solve this problem.
>>>
>>>What I have in mind and seek comment from fellow listers seems 
>almost 
>>
>>>too
>>>simple a fix:
>>>
>>>At great risk to my person I took from our kitchen sink the sink 
>plug 
>>
>>>- 50
>>>mm (2") diameter - exactly the right size to force fit into the 
>>inside 
>>>of
>>>the wheel hub. Once in place it can't go anywhere being held in by 
>>the
>>>wheel spinner. I don't reckon any oil will get past that baby. What 
>>do 
>>>you
>>>reckon?
>>>
>>>Apart from getting into real trouble for pinching the plug can you 
>>see 
>>>any
>>>problems?
>>>
>>>Paul
>>>
>>>
>>>

<Prev in Thread] Current Thread [Next in Thread>