In message Fri, 13 Dec 1996 08:23:13 -0500,
stevet@hbp.com (Steve Tritle) writes:
> Is there an 'easy' way to reverse the bottom portion of the screen
> frame? It seems the restorers put the bottom of the frame in backwards.
> The holes for the Auster name plate are on the outside not on the inside
> of the car as it should be.
> Can I remove only the bottom portion of the screen and reverse it or do
> I have to take off the entire screen?
>
> Any informed suggestions appreciated.
Steve..
If the folks that assembled the w/s, used the proper w/s packing and did not
use any adhesive, you MAY be able to remove the bottom portion. If you fold
the w/s amd remove the two screws in each corner you may be able to wiggle
it loose. If you get much resistance, I would remove the whole w/s from the
car and do the disassembly on a table. Place a blanket under the w/s
before starting work
Let me know how you make out.
Press on regardless,
Blair
50 & 53 TD
______________________________________________________________
Blair Engle engle@phy.fsu.edu
|