Does anyone have any suggestions for repairing/replacing the welded frame
brackets that hold the inner fulcrum bolt and special washers on the
wishbone/lower suspension member on a Sprite. This is the bracket with the
large round hole with the small rectangular slot above it. Someone has made
a modification so the the washer doesn't sit in the hole properly nor does
the tab in the special washer with the tang on it. This is the washer that
presses against each bush in the wishbone. Only one of the four holes on
each side of the car has been modified and I would like to fix it
correctly. Any advice or experience in this area would be appreciated.
Thanks in advance.
Gerard
-----------------------------------
Gerard Chateavieux
3D Artist/QA Engineer
Macromedia- San Mateo Engineering
----------------------------------------------------------------------
"Don't miss the Macromedia European User Conference and Exhibition,
December 4-6 1996, RAI Centre, Amsterdam, The Netherlands.
To register, call +44 1344 458600."
|