On Tue, 15 Oct 1996 BarneyMG@aol.com wrote:
> ... If the oil is not running back fast enough I need to increase the
> drain back flow capacity, presumably by opening up the holes in the head
> around the pushrods. Where else could the engine store that much oil but in
> the valve cover? And how long would it take? Does anyone know the flow
> volume of the oil pump?
The shop that machined my block recommends two ways to increase
drainback; paint the rough inside surfaces of the block with Glyptal,
or polishing the block casting itself- neither of these will probably
thrill you.
--Scott
Scott Hower --> howersl@ttown.apci.com
Air Products & Chemicals, Inc.
7201 Hamilton Blvd Trexlertown, PA
(610) 481-2646
|