RE: Engine regbuild - 70b

[merryweather@venus.connectware.com]

My machine shop prefers to thread ALL oil galley holes, and put in a threaded 
allen head screw with some loctite.  Then it is easier to get them out again, 
if needed.  But as you see, it gets confusing at the time of the next 
rebuild.  As far as the soft plug is concerned, if you use the proper size 
plug, it will hold well above any maximum rated oil pressure.  The oil 
pressure relief valve will go before any plug.

George Merryweather
merryweather@connectware.com