Date: Mon, Jun 24, 1996 2:42 PM EDT
Vadim wrote:
>I'll let others comment on what the best top manufacturer is, but I do
>have an installation tip. When drilling out the old rivets, many times
>the far end will fall off into the header rail. Then when driving
>around, the metal pieces bounce around, making casino-like clincking
>noises. They won't come out through the holes (holes are too small).
>Solution: before putting on the new top, drill a larger hole somewhere
>towards the side of the header rail, in the part that will have the top
>glued to it. Then empty out all the debris from the header rail before
>rivering and gluing on the new top. Much quieter.
Another good solution for this is to fill the header rail with insulation
foam (usually comes in a spray can with convenient nozzle, used for filling
in around electrical sockets in houses). Not only does it sort of freeze up
all the old junk in there, but it also helps insulate a bit against wind.
Corey
75 MGB 'Rags'
|