At Sat, 4 Nov 95 09:14:02 EST, ciaffone writes:
> Is my 72 Midget SUPPOSED to have its plug wires seemingly a
> part of the distributor cap?? I had not looked closely enuff when the guyz a
> t
> the local BritCars place sold me replacement wires, but they won't fit. Any
> suggestions where I might purchase what seems to be a distributor cap with
> wires attached??
There are little pointed screws on the inside of the cap which screw
up and through the wires in the cap. Cut off the snap-on connector
ends on the distributor-cap-end of each wire and shove it in the hole.
Now screw the pointy screw through it. Voila! You may have to go the
the hardware store to buy a screwdriver which is both long and narrow
enough to get to those screws properly. Personally, I love this
system as it seems much more secure than modern snap-down wires.
--
| Matt Liggett <mliggett@indiana.edu> |
| http://seven.ucs.indiana.edu/~mliggett/ |
|--------------------------------------------------------------------|
| 1974 Ford Bronco Ranger 1970 MG Midget 1978 Honda Civic 1200 |
|