>
>Are your timing values with the vacuum connected or disconnected.
>
>I don't have a manual to hand at the moment (its at home - I'm not!) but you
>might find that the teeth of the comb are every 4 degrees giving a timing range
>from 20 degrees BTDC to 0 degrees BTDC.
>
>I could post the values from my workshop manual tomorrow, but someone will
>probably have posted the correct values by then.
>
The timing marks are 5 degrees apart commencing with top dead centre (and
this is from the factory manual).
Be careful of too much reliance on the marks. The bottom pulley has a
rubber centre, designed to remove harmonics from the crankshaft and there
can be a slight turning. If in doubt find top dead centre by taking No 1
spark plug out, establishing top dead centre and then seeing where that is
in relation to the timing marks and then 'lay off' the error, if any.
Regards>
Graham McCann Rivett, ACT. Australia
gmccann@pcug.org.au
06 2889055
______________________________________________________________
|