>Subject:
>Author: wkube@iadfw.net at BALT.SMTP
>Date: 8/14/95 11:27 AM
>
>
>I am restoring a '79B. I have removed and cleaned the fuel tank. There was
>some minor rust on the top surface that did not penetrate through to the
>inside. Outside has been derusted, primed, and painted. Minor surface rust
>on the inside. I have the Moss etching solution and slushing compound but
>have not used it yet. Questions:
>
>1. Anyone used this stuff before?
>
>2. Any pros or cons?
>
>3. Any cautions to be aware of?
>
>4. Any additional advice?
>
>Thanks for your thoughts on this.
>
>Wayne M. Kube
>Plano, TX
>'79B slowly going back together....
>
The only long term solution I've found to be successful for 'B' petrol tanks
(on both 'B's I've owned; '69 & '70) is to get a stainless steel one (&
'Hammerite' the boot floor above it before fitting). Same goes for the exhaust.
Kevin
========================================================================
Mail: Kevin Buckley #####
The Technology Partnership Ltd #####
Melbourn, Royston #####
Herts. SG8 6EE UK #####
Tel: +44 1763 262626 #####
Fax: +44 1763 261582 THE TECHNOLOGY PARTNERSHIP
EMail: kb@techprt.co.uk #####
========================================================================
|