> Date sent: Thu, 22 Jun 95 21:17:49 MDT
> From: slindsay@nyx10.cs.du.edu (Steve Lindsay)
> To: mgs@autox.team.net
> Subject: distributor removal
> Send reply to: slindsay@nyx10.cs.du.edu (Steve Lindsay)
> I am trying to remove the distributor from the block without
> any luck. I have removed the two bolts that hold it to the block
> and it does not budge. I then loosened the adjusting bolt and now
> that part that was bolted to the block will spin but the distributor
> is still as solid as a rock. It will not even rotate if I wanted to
> adjust the timing.
>
> This is a 1978 B that has not been started for 10 years. Shouldn't
> the distributor be free to turn and slide in and out or is there
> something else holding it?
>
>
I bet'cha it's rusted in place. Soak it in wd-40. Then, try it
again.
|