mgs
[Top] [All Lists]

Re: Datsun parts for MG's

To: Jerome Kaidor <jerry@tr2.com>
Subject: Re: Datsun parts for MG's
From: "Gary R. Burrell" <burrelgr@tuns.ca>
Date: Thu, 18 May 1995 09:09:01 +0100
On Wed, 17 May 1995, Jerome Kaidor wrote:

> 
> **** One Japanese part that would interest me greatly would be a 
> decent clutch throwout bearing to replace the !@#$# carbon one that comes
> in MGBs and MGAs.  You know, the kind that you can put your foot on
> without being paranoid, and hold down until the light changes.
> 
>     The first throwout bearing I put in my `A only lasted 10,000 miles!
> 
>    I wonder if there's another bearing that's close enough in size to use?
> 
>                                  - Jerry Kaidor
> 
> 


Well Moss, VicBrit and Seven sell roller release bearings which are of
the ball bearing type, but they cost 4 times as much.  I don't know if they
are the same size as the one used in the MGA, but they probably are.

Gary


MasterClk__| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_|
         __:___:___:___:___:___:___:___:___:___:___:___:___:___:___:___:
Character__|20_|47_|61_|72_|79_|20_|42_|75_|72_|72_|65_|6C_|6C_|20_|20_|
               :_______________:   :                           :
FirstName______|               |___:___________________________:________
                                   : __________________________:
Surname  __________________________|                           |________
Electronic Signature: Gary R. Burrell P.Eng. (burrelgr@tuns.ca)




<Prev in Thread] Current Thread [Next in Thread>