mgb-v8
[Top] [All Lists]

[Mgb-v8] crank/transmission alignment

To: mgb-v8@autox.team.net
Subject: [Mgb-v8] crank/transmission alignment
From: "James J." <m1garandusa@verizon.net>
Date: Sat, 10 Oct 2009 17:16:33 -0400
All,
    My machinist asked me if I had measured the concentricity of the T-5 
(ford), adapter-plate (D&D Fab), Bellhousing (Buick 3/4 speed) and crank 
(Buick 300 in Rover 3.9).  This was in regards to making a pilot bushing 
to adapt the crank to the Ford T-5.  When I shrugged and said "nope", he 
also pointed out that some manufacturers held to better tolerances than 
others.

Did most folks here have their set-up measured and use eccentric pins to 
correct for errors, or did most folks here just bolt up and drive???
V/R
James.
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Mgb-v8 mailing list


Mgb-v8@autox.team.net
http://autox.team.net/mailman/listinfo/mgb-v8

<Prev in Thread] Current Thread [Next in Thread>
  • [Mgb-v8] crank/transmission alignment, James J. <=