To: | mgb-v8@autox.team.net, mgs@autox.team.net |
---|---|
Subject: | Gear shift knobs |
From: | Barrie Robinson <barrie@look.ca> |
Date: | Sun, 27 Nov 2005 14:34:50 -0800 |
Reply-to: | Barrie Robinson <barrie@look.ca> |
Sender: | owner-mgb-v8@autox.team.net |
A wood local turner made me a bird's eye and ebony gear shift but due
to bad glue (weak crazy glue) it came apart. Now he says he can make
another and I have decided on solid black Indian ebony. However they
only sell it in 2" X 2" X 18" pieces - enough for 6 knobs! Is there
anyone out there that would want one of these. The cost of the wood
per knob works out at $8 and I think he would turn them for $15
each. So allowing for postage the bill would be roughly $25. They
would be solid with a hole into which you would have to fit a 1/2"
wide 7/8ths long tapped nut which I have found in the local hardware
store. I need a 5/16 NC 18 pitch one as I have a Rover SD1 gear
lever but others must be available. The hole would be just over
1/2". Nothing on the top as I cannot find those gear shift pattern
things as normally appears on knobs. Barrie Robinson 705-721-9060 MGB GT V8 Aston Martin DB 2/4 MkII in the wings Purveyor of O-ring kits for Smith and Jaeger gauges ------- and of stainless steel mesh grilles for MGBs ------- and of bitumastic soundproofing /// /// mgb-v8@autox.team.net mailing list /// Send admin requests to majordomo@autox.team.net /// Send list postings to mgb-v8@autox.team.net /// Edit your replies! If they include this trailer, they will NOT be sent. /// |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Panhard rod, Michael Hartwig |
---|---|
Next by Date: | Off Topic - Computer Question, Barrie Robinson |
Previous by Thread: | Panhard rod, Michael Hartwig |
Next by Thread: | Off Topic - Computer Question, Barrie Robinson |
Indexes: | [Date] [Thread] [Top] [All Lists] |