At 9:59 AM -0400 8/22/01, Barrie Robinson wrote:
>Folks at world,
>
>My Rover V8 is installed in my MGB GT and so is the rear axle - Now I need
>a prop shaft. I have the MG end and a rotten (there appears to be a rubber
>seal that has expired) Rover end which was cut at the hollow tube bit.
>
>Advice on suitable prop (drive) shafts would be much appreciated - or if
>you have one for sale!
>
>My thanks in advance
Most driveshaft shops will make custom driveshafts for you pretty
reasonably. All you need to tell them is length and what the two ends
will be. I haven't had one made myself, but I know they do this and
other conversionists have done this and paid anywhere from $80-$125
for the service.
good luck!
Joe Pitassi
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|