Assuming the wiring to the switch is present you just use the yellow which
should terminate in a single bullet-connector somewhere. Don't know how the
switch will stand up to the current of the fan if you don't have a relay,
which you don't mention. Neither is it fused anywhere, you might want to
fit an in-line. If you don't have a relay and want to use one you might
like to have a look at the web site below which shows how the factory V8 -
which always had a relay and twin fans - was wired. Click 'Spanners',
'Electrics' and 'Cooling Fans'.
PaulH
http://www.mgb-stuff.org.uk
----- Original Message -----
From: Bruce <brucemills@dccnet.com>
To: MGB Newsgroup <mgb-v8@autox.team.net>
Sent: Tuesday, April 17, 2001 6:38 PM
Subject: Manual Over ride
> I just received my electric fan and sending unit with a temperature
control
> unit to adjust the temperature at which the fan kicks in.
> I would like to use the now defunct steering column OD switch (with wiring
> in the engine bay) as a manual over ride.
> I once managed to locate a web page that had a diagram but it seems as if
I
> neglected to book mark it and now of course I can not find it. I was
> wondering if any one could provide me with the diagram to run a manual
over
> ride?
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|