Kevin, I have the RV8 style headers and the holes were cut and then an edge
was folded downward so there is a 1/4 lip all the way around the hole. It
was then made contiguous and short welds to close the ring.
Joe Potter
Eugene, Oregon USA
www.hometown.aol.com/capaciousmg/vasale/vamain.html
http://hometown.aol.com/jtpaki/index.html
In a message dated 2/18/01 4:44:28 PM Pacific Standard Time,
MGTRAutoXr@sprintmail.com writes:
>
> I am installing RV8 style through the fender well headers in my car. I
> know on the RV8 they reinforces the holes by installing spot welded
> sheet metal around the edge. Has everyone done it this way or has
> anyone not reinforced the holes? If so, have you had any problems?
> Reinforcing wouldn't be a big deal if the inner fenders were flat, but
> since they curve to various degrees, it will be hard to form a piece of
> sheet metal to conform to the curves. Thanks.
>
> Kevin Brown
> Odessa, MO
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|