mgb-v8
[Top] [All Lists]

MGB Crossmember

To: <mgb-v8@autox.team.net>
Subject: MGB Crossmember
From: "Bruce" <brucemills@dccnet.com>
Date: Sun, 10 Dec 2000 17:38:48 -0800
Reply-to: "Bruce" <brucemills@dccnet.com>
Sender: owner-mgb-v8@autox.team.net
With my 74 1/2 MGB I am now taking a look at the tranny cross member. It has
been suggested that I would be able to use the original crossmember, and
with a little modification, drill another hole (in the frame) to the rear of
the existing holes which would allow the cross member to line up with the T5
tranny mounts almost perfectly. If I do drill a hole further back is there a
plate there to tap new holes into or is it just going into sheet metal?

Bruce

<Prev in Thread] Current Thread [Next in Thread>