Insufficient information, Gerry. Does the gear selector move into all four
forward gears and reverse when the engine is off? Or does the shifter not move?
If the former, does it not go into gear because there's a terrible grinding
when the engine is running and the clutch pedal depressed. Did you adjust the
clutch pedal travel and free play according to the manual? On a TC, both these
measurements are critically important. When you push the clutch pedal does it
feel as though it is doing what it used to - i.e. compressing the springs of
the clutch pressure plate? If it simply doesn't move properly, perhaps you put
the disc in backwards.
Lawrie
> -------Original Message-------
> From: Gable, Gerry <GABLEG@ecu.edu>
> To: mg-t@autox.team.net <mg-t@autox.team.net>
> Subject: [Mg-t] Transmission Question
> Sent: 08 Oct '15 09:53
>
>
>
> I pulled the Trans to replace the clutch disk on my TC. Engine and
> Trans out of car. When I reassembled I cannot get it to go into gear.
> It worked before and should work now. Cannot think of any reason it
> does not. Did I destroy something serious?
>
> Thanks
>
> Gerry
> -------------------------
> ______________________________________________
>
> Mg-t@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/mg-t/lawrie@britcars.com
>
>
______________________________________________
Mg-t@autox.team.net
Archive: http://www.team.net/archive
|