I would recommend removing them. Easier to paint.
You could buff, or scotchbright after blasting, to give a shine.
I place a #10 nylon washer between the strips and the running board.
Easier to clean under the strips, once attached again.
John Seim
Irvine, CA
On May 12, 2013, at 10:48 AM, Rick Lindsay wrote:
> Hi Friends,
>
> My TD's running boards are in good shape but of course, they'll get painted
with the rest of the car. B And the aluminum strips are in good
condition...and riveted on. B There is no rust at the strips. This leads me
to the question; Do I drill out the rivets and install the new Al strips, OR,
just use the strips I have after media blasting? B They will be matte aluminum
after media blasting BUT, the new strips I have now are also matte finish! B
I'm thinking I should leave them in place, mask them off before primer and
paint, then install the new rubber treads after the paint cures. B
>
> Thoughts? B Advice? B Thanks.
>
> -rick
> Sent from my Samsung Galaxy SIII - the rectangle with rounded corners, just
like a BlackBerry.
> ______________________________________________
>
> Mg-t@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/mg-t/kingseim@earthlink.net
______________________________________________
Mg-t@autox.team.net
Archive: http://www.team.net/archive
|