Hi Friends,
I spent some time this morning stripping paint and assessing rust
damage. And of course, I took a few pictures. To start, here's the
passenger rear quarter with the running board off and the rear wing
partially removed (read: loose).
http://www.aubard.us/MGTD/HPIM1192.JPG
In that picture I have done nothing other than strip the paint and
wipe the metal clean. No sanding, no grinding. That will come later.
Here's a look at the worst damage on the entire car.
http://www.aubard.us/MGTD/HPIM1193.JPG
The metal is rusted away and 'some' of the wood is decayed. However,
this timber is about 2" thick so the 1/8" of wood that's
surface-eroded, is not (in my opinion) a real issue. When poked with
a screwdriver, the wood is sound everywhere. I'll vacuum this whole
area out, seal the timber with a wood preservative then replace the
metal.
Here's another look at the door opening. I would have removed the
rear wing BUT, the damned previously-captive nut has broken out of its
cage. Its also NOT available to be held, being deep down between
welded panels. :-( Gurrrr. I hate rusted bolts. And in this case,
I'm going to have to cut this rusted bugger off!
http://www.aubard.us/MGTD/HPIM1194.JPG
Here's another look.
http://www.aubard.us/MGTD/HPIM1195.JPG
The running board came off pretty easily, for rusted bolts. It is
beautifully undamaged and will be easily refinished.
http://www.aubard.us/MGTD/HPIM1196.JPG
Before realizing that the front once-captive nut broke free from its
'captivity', I removed the tail light and left the wing hanging on one
top bolt (and the stuck one).
http://www.aubard.us/MGTD/HPIM1197.JPG
After getting cleaned up, I clipped the toothpick-wood-repairs off but
haven't yet sanded the surface. I'll wait until I've repaired the
remaining tack holes, the screw holes and any gouged wood, before
refinishing that inner surface with wood sealer.
http://www.aubard.us/MGTD/HPIM1199.JPG
http://www.aubard.us/MGTD/HPIM1200.JPG
And finally, I can't believe I've gone this long - over 45 years -
restoring cars without owning a set of these wheel dollys!!! They're
genius!
http://www.aubard.us/MGTD/HPIM1198.JPG
Best regards from a dirty garage in Houston,
-rick
______________________________________________
Mg-t@autox.team.net
Archive: http://www.team.net/archive
|