On Mon 07 Nov 2011 at 07:55 AM EST, gunnellj tds.net <gunnellj@tds.net> wrote
to Chip Old :
> Chip
>
> OK. Her's what I wanted to ask.
>
> I have a 1950 TD that I am redoing as a hot rod. I bought it for $500. On
>this car the brake drums were held on with short, fat screws that had a taper
>at the slotted end. The car was so rusty that these screws got more or less
>ruined. In fact, on one side I drilled them out and the threads would need
>repair.
>
> My 1952 TD has a different style of brake drums without the screws. Are
>the two types of drums interchangeable? Or more correctly, can the later style
>be used on the earlier car?
>
> Also having trouble getting one of the "castle nuts" off the hub. Are they
>both normal threads or does one side have a reverse thread?
>
> John Gunnell
> Iola, WI
John,
You really should have posted that to the group, not directly to me. There are
lots of group members who know the finer points of the TD a lot better than I
do. I'm replying to the group so others can pitch in.
If I remember correctly (which could be a problem):
Early TD brake drums are separate from the hubs. The countersunk machine screws
are to make sure the drum is centered on the hub, and to hold the drum and hub
together when the lug nuts are removed. The ends of the countersunk screws are
peened over after assembly, to prevent disassembly. According to the TD/TF
Workshop Manual the drum and hub are not meant to be disassembled.
Later TDs have one-piece hubs and drums.
As far as I know the two types are interchangeable, but you should ask the TD
experts in the group to make sure.
If you're talking about the front hubs, the right-hand side has a right-handed
thread, the left-hand side has a left-handed thread.
--
Chip Old <feold3@mac.com>
Cub Hill, Maryland, US
1948 M.G. TC TC6710 XPAG7430
______________________________________________
Mg-t@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|