I am in the process of rebuilding the rear brakes of my MG TD. Everything is
clean now. What type of lub do I use for the area where the wheel cylinder
assembly (Moss 180-630) slides up and down? Should I use brake grease,
silicone, oil or leave it dry. My concern is that if lubed, then it could
attract dirt and cause problems in the future. I find nothing in the
workshop manual pertaining to lubricating this part.
Also, I find that after I clean the drums with brake cleaner, they tend to
rust. Should I smear a light coat of oil on the areas not contacted by the
brake shoes? How to prevent rust?
Thanks for your help, one and all.
Stu Keen
1951 MGTD Mark II
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|