Hi John,
When we found it necessary to shorten the Crane pushrods, removal of
one end ( it may have been the ball end, but I do not remember with
certainty) pulled right out of the tube; the end was not spot welded.
Use the catalogue measurement as a place to begin, but fit the
gasket, head and rocker assy loosely so that you can check the necessary
length of the pushrod to fit your engine.
Bob
On Sat, 23 May 2009 09:47:26 -0400 gunnellj@athenet.net writes:
> Hi Mates
>
> We have discussed this previously, debating whteher the "long" push
> rods Moss sells would work in my rebuilt XPAG engine with the Crane
> cam and the machined head.
>
> The debate is over. The rocker arm assembly came back from Rocker
> Arm Specialists and when we installed in the push rods were too
> long.
____________________________________________________________
All is not lost! Click now for professional data recovery.
http://thirdpartyoffers.juno.com/TGL2141/fc/BLSrjpTLygH8hjUgkaooNyq5vZfSSiI9RrmM2qnK6pM5H8hgey7SIMyrmyE/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|