Hi Herb,
I assume you mean a late TD/TF filter? If so, remove oil filter cannister.
Install a short piece of 3/8" rod through the two holes in the adapter (
Moss # 435-140, page 5, p/n 131 ) oil filter to pump, now unscrew the
adapter. Normal right hand thread. It will be TIGHT, so you will need some
leverage. I have used a large pipe wrench sideways across the two sides of
the 3/8" rod.
Good luck.
Bob Grunau
-----Original Message-----
From: mg-t-bounces@autox.team.net [mailto:mg-t-bounces@autox.team.net]On
Behalf Of herb strachman
Sent: Sunday, April 05, 2009 11:23 PM
To: MG
Subject: [Mg-t] Spin on oil filter question
Greetings,
I'm installing a new spin on oil filter and would like to know how to remove
the old filter bolt to pump.
Thanks,
Herb Strachman
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|