Ditto on TD 25937- The flat part of the rubber that is tacked to the wood
is
cut out for the base of the clip that holds the rear of the hood hinge
piece. The clip sits on and is screwed to the wood.
This leaves the rib of the rubber piece continuous around the cowl.
FWIW
Dallas
----- Original Message -----
> From: <yd3@nvc.net>
> To: "Bob Howard" <mgbob@juno.com>
> Cc: <grunau.garage@sympatico.ca>; <Douglas.Ormrod@neurological.org.nz>;
> <mg-t@autox.team.net>
> Sent: Tuesday, November 07, 2006 4:43 PM
> Subject: Re: hood (bonnet) rubbers
>
>
>> My TD, 25335,, has a one piece rear bonet rubber and notched for the
>> hinge clip. It is original. That way the part that laps over the cowl is
>> continuous. If you check period pictures you will find see that.
>>
>> Regards,
>> Blake
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|