Bill, I took following measurements for the position of the centre of the
hole.
- centre of hole to horizontal body seam (along a vertical line): 87 mm
- centre of hole to centre of rear bracket hole (along a horizontal line):
50 mm
As far as the hole diameter, I recall it is of about 10 mm, but this depends
on how much paint has been sprayed on the body.....
Regards.
Jeszs
53 TD
-----Mensaje original-----
De: owner-mg-t@autox.team.net [mailto:owner-mg-t@autox.team.net] En nombre
de Bill Snyder
Enviado el: lunes, 20 de febrero de 2006 17:35
Para: MG T List
Asunto: Hole Location for Wiper Motor (TD)
Hello list and thanks for your input on mounting my TD Windscreen. The job
was done this weekend and it looks great!
What I need now is the proper location and size of the hole in the cowl for
the windscreen wiper motor wire. Can anyone take a few measurements for me?
It there any type of grommet at the site?
Thanks again in advance.
Bill Snyder
'53 TD The end is in sight!
/
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|