Hi,
My TD has now one bracket installed and the other not. I can take
measurements and pictures of both sides. I will send them to you in less
than 24 hours, if you do not need them earlier.
Jesus
53 TD
-----Mensaje original-----
De: owner-mg-t@autox.team.net [mailto:owner-mg-t@autox.team.net] En nombre
de Bill Snyder
Enviado el: lunes, 06 de febrero de 2006 15:10
Para: MG T List
Asunto: Winscreen bracket Installation
Hello list. I am to the point in my '53 TD resto where I need to install the
cowl mounted windscreen support brackets. The problem is that I have a
restored tub (professionally restored in 1964 and stored since) that has no
screw holes. Can anyone get a few measurements with or without photos from
their TD's to help me properly locate the screw holes. I guess measurements
could be made from the bottom edge of the cowl and from the front or rear
edge of the cowl. Any and all help and advice appreciated.
I am also assuming the the best way to mark the holes is to have the
brackets attached to the windscreen and then to set the entire assembly on
the cowl for marking. Any corrections or better ideas?
Thanks.
Bill Snyder
Waynesville, NC
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|