Tom,
There were only four studs that were installed at Abingdon. The
others have been installed to fit full tonneau covers. The original cover
fastened to two on the rear panel and two near the angle where the sides
of the boot curve down to the door. Its forward edge slipped between the
back of the squab and the horizontal black bar, then was pulled down by
elastic straps to lift-the dot studs down on the squab. If you don't
get the pictures you need, write back and I can measure for you those
that have never been moved on my car.
Bob
On Sun, 16 Oct 2005 09:05:02 -0700 (PDT) tom zylla <bugeyeguy@yahoo.com>
writes:
> List,
> The TD body is back from the shop with new cream paint
> but they filled all the holes for the tonneau studs.
> I'm thinking there were 14 of these total, with 6 of
> them being in the cowl area and the remaining 8 on the
> tub.
> I need to get a photo of the rear and side of a TD
> showing locations for these studs so I can fit my new
> tonneau.
> Appreciation in advance,
> Tom
> 1950 TD#1849
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|