Rocky,
Bearing cleanances are given in the "General Data" section. I don't have a TF
1500 workshop manual. For the TF XPAG (NOT XPEG) the rod bearing
cleanances are 0.0005 to 0.002 inches. You should find similar data (probably
the same) in the general data section.
W.K.F. Woods in his book lists "oil clearance 0.0008-0.002 in." for XPEG
engines.
Regards,
Blake
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|