mg-t
[Top] [All Lists]

RE: Temperature

To: <mg-t@autox.team.net>
Subject: RE: Temperature
From: "Gene Gillam" <anngene@bellsouth.net>
Date: Wed, 6 Apr 2005 18:24:06 -0500
Dave,
Phew...just realized that the 0 before the F in the below numbers meant
"degrees" - otherwise you'd have to be driving that TD in hell.
Gene



-----Original Message-----
From: owner-mg-t@autox.team.net [mailto:owner-mg-t@autox.team.net] On
Behalf Of Dave & Liz DuBois
Sent: Wednesday, April 06, 2005 5:41 PM
To: John Gunnell
Cc: mg-t@autox.team.net
Subject: Re: Temperature


John,

I agree with Bob Howard, that you should stick a candy thermometer in 
the radiator fill neck and see that your temperature gauge on the dash 
is telling you the correct temperature.  Once you have verified that, 
then you can look at the gauge with a little more confidence.  As to how

high is too high, as long as the engine is not boiling while the car is 
moving, you are NOT overheating regardless of how high the gauge goes (I

have seen the temperature portion of the dual oil pressure/temperature 
gauges go past the high end of it's range and start  pointing into the 
oil pressure portion of the gauge and the engine wasn't boiling).  As 
soon as the car stops moving and the engine is shut off, it may start to

boil, but that is normal and nothing to worry about.  Consider that if 
you have a 25% mixture of antifreeze in the coolant, the boiling point 
in a unpressurized system like on the TD is around 1040C (2180F) and for

a 50% mixture of antifreeze it is 1080C (2260F), so I would not start 
worrying until the needle moved past the 1000C mark.  Even then, I would

just keep my eye on the gauge to see if it continues up and how fast.  I

run a 850C thermostat in our TD, so once the engine is warmed up 850C is

the minimum temperature we see on the gauge, with excursions up to 
between 950C and 1000C.  As long as the temperature starts down once the

strain is off of the engine, I am happy.

The poor running could have been a flake of carbon getting lodged in an 
exhaust valve for a while and then finally blowing out or sedement from 
the float bowl breaking loose and getting stuck in the jet for a bit.  I

think that I would do a compression check and re-check the carburetor 
settings, but beyond that, as long as the car continues to run all 
right, I don't think that I would worry too much about it.

Cheers,
Dave

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.3 - Release Date: 4/5/2005

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t


<Prev in Thread] Current Thread [Next in Thread>