Thanks, Eric.
All the best, David
----- ORIGINAL MESSAGE -----
From: "Eric Worpe" <E.Worpe@surrey.ac.uk>
To: mg-t@autox.team.net,archie_ponsonby@post.cz
Subject: Re: [mg-tabc] Metal thickness
Date: 19.1.2004 - 15:30:53
> Hi David,
> The steel sheet thickness for most of the T
> type body parts was around
> 20 SWG or 36 thou. (0.036 inches), this is
> about 0.9144mm which works
> out at a CSA of 0.657mm. The only conversion
> tables I've found give the
> following:-
> 21 AWG = 0.590mm ( AWG = American Wire
> Gauge )
> 20 AWG = 0.750mm
> So, to answer your question, somewhere
> between 20 and 21 AWG.
> Regards, Eric.
>
> ----- Original Message -----
> ----- -----------------------------------------------
> > To make up for my last two wildly off-topic
> > posts, does anyone
> > know the North American thickness of the TC
> > wing and petrol tank
> > sheet metal? Many thanks.
> >
> > Regards, David Lodge
>
>
>
--
Zapojte se do ankety Motocykl roku 2004 a my>ete vyhrat
Kawasaki ER-5 a dal9m ceny timlx za 300.000 tismc korun.
Dejte hlas nejlep9m motorce na http://www.motocyklroku.cz
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|