Hello List,
I just acquired an early MGTD (car# TD1849) and
proceded to join this list.
Upon looking over the front brake drums I found that
one side has coarse threads and a felt seal with
waffled washer. The other side has fine threads and a
bearing cap in the center of the drum. Obviously
somewhere along the line prior to me, one side has
been changed. In order to have them match, I'm
thinking that I'll have to change one of them.
Are the spindles the same for both types or am I going
to have to rebuild the entire front end? Can I change
just the studs and lug nuts? I could just leave it the
way it is and keep track of the lug nuts... and keep
the hub caps on or I could make both sides the same.
What say you?
Cheers,
Tom Zylla
TD1849
Cameron Park, CA
__________________________________
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|