Distributer housings.

[Bullwinkle <yd3@nvc.net>]

My turn:

<<<snip>>>
to reswage the body to the shaft
<<<snip>>>
Now there's a question.  Not having wanted to destroy a distributer
housing I've never attembted to seperate the steel shaft section from
the die cast housing.  Is the steel bearing housing cast into the die
cast point housing or is it pressed on?

Blake

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t