Hello!
I looked around I couldn't come up with the answer so I will ask here.
I am looking for the correct thickness of the floorboards and rear deck
plywood. I wouldn't question it, if they were the same, but on mine they are
not. The rear deck plywood measures 1/2" and the floorboards measure 3/8". I
figured I could make these out of one sheet of birch plywood... but because
they were different, I questioned it... I would make them both out of 1/2" but
the thickness will drive the transmission tunnel alignment with the
firewall... maybe on the other hand we are only talking 1/8" - 1/6"
differnce... but what is the "correct" thickness supposed to be?
Thanks,
Blair
NEMGTR #993
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|