Chuck,
K&N filters E3290 fit very nicely. It is a bit of a tight fit, but they
work well. The size is 6.25" OD, 5.25" ID and 1.5" height. The perforated
ring goes away.
The one snag is the breather nipple. It may protrude slightly on the
inside, not allowing a good seal. Move it inward to eliminate the
protrusion and to assure that the breather tube gets filtered air. Brazing
works well.
Ben
54 TF 1500
----- Original Message -----
From: Chuck Hull <chull@pacbell.net>
To: <mg-t@autox.team.net>
Sent: Thursday, November 30, 2000 8:37 PM
Subject: Air Filters
> I have been cleaning up and painting the air filters for my wife's 1955 TF
> 1500. After cleaning the original wire mesh and re-oiling it, I wondered
> it there was a more modern filter that would sit inside the perforated
> metal ring that sits between the two metal plates. Does anyone have a K&N
> filter number that would fit?
>
>
> Chuck
> 1955 MG TF 1500
|