Dave,
Thank you for the suggestions. I will forward them to him this morning.
That the wheel shop told him the runout on his wheels was within spec,
while the runout I measured on my wheels was so much less, certainly
raised questions in my mind.
Bob
On Mon, 24 Jul 2000 09:47:27 -0700 Dave and Liz DuBois
<ddubois@sinclair.net> writes:
> Bob,
> I would have your friend find another wheel shop, 3/16 inch
> runout
> is definitely excessive. He should also have the rear wheels
> checked
> for runnout and out of round condition - it was the rear wheels on
> my
> car that caused the condition that your friend is experiencing (and
> they
> had less than 3/16 inch of runout before I had them repaired). tell
> your friend to check with British Wire Wheel in Watsonville, CA. I
> believe that they have a disk wheel straightning service. Their web
> site is :
> http://www.britishwirewheel.com
>
> Good luck,
> Dave
>
|