To: | mg-t@autox.team.net |
---|---|
Subject: | RE: Source and size of TF screws, bolts & Taps |
From: | Bullwinkle <yd3@nvc.net> |
Date: | Sun, 09 Apr 2000 17:31:03 -0700 |
And at least two different drill sizes for the taps: 1/4 by 28 requires a # 3 drill (0.213) and the 8 by 1.00 mm requires a J drill (0.277). If my chart is right, and I haven't transposed numbers again, the 8 mm is quite a bit larger. Thanks Lew for catching my switcheroo. BTW the 8 by 1.00 on my chart says French (remember Hotchkiss?) and the 8 by 1.25 mm (requires a 17/64 drill, 0.265) says D.I.N. |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Source and size of TF screws, bolts & Taps, JustBrits |
---|---|
Next by Date: | RE: Source and size of TF screws, bolts & Taps, Lew Palmer |
Previous by Thread: | Re: Source and size of TF screws, bolts & Taps, JustBrits |
Next by Thread: | RE: Source and size of TF screws, bolts & Taps, Lew Palmer |
Indexes: | [Date] [Thread] [Top] [All Lists] |